Netopia Wireless 3347 - DSL Modem Setup

Before you begin...

Below is a front and back view of the Netopia 3347. Be certain that the Ethernet cable, phone cable, and power cable are connected properly before continuing setup.

	Front Panel - Lights Wireless Link: Blinks green when transmitting. LAN 1 - LAN 4: Blinks green when Ethernet is connected. DSL Sync: Solid green when DSL signal is detected, blinks when no signal detected. Power: Solid green when powered on.
	Rear Panel Ports DSL: Plug in an unfiltered phone cord. LAN 1: LAN 4: Plug in an Ethernet cable. Power: Plug in the supplied AC Adaptor. Off/On: Turn DSL modem power off/on.

Configuring the Netopia 3347NWG

• Browse to http://192.168.1.254.
• On the left menu, enter Expert Mode, click Configure, then Connection.
• The following settings should be configured:
  • VPI: 0 (Users with Embarq/Centurylink phone service should use 8)
  • VCI: 35
  • Protocol: PPPoE
  • Username: Your DSL username
  • Password: Your DSL password
  • Connection Type: Always on
• Click the Save Changes button. If the connection is successful, a Connection Information page will be displayed. screenshot
• On the left menu, click the Configure button, and then the Wireless button. screenshot
• If your DSL modem has been pre-configured, continue to step 7. If the modem has been reset, do the following before you continue:
  • Click the Advanced Configuration Options arrow.
  • Next to Privacy: choose WPA - PSK from the menu. screenshot
• Configure your wireless options as needed: screenshot
  • Enable Wireless: Turns your modems transmitter on/off
  • Wireless ID(SSID): This is the name of your network that will be broadcast to your computer.
  • Default Channel: Default is 6. Change if you are having problems with wireless range.
  • AutoChannel Settings: Recommended OFF
  • Privacy: Keep on WPA - PSK
  • Pre Shared Key: This will be the password required for wireless access. It needs to be 8 characters or more.
• Click Save Changes when complete, then close the browser window.

For assistance with setting up your wireless connection, click here.

Advanced Settings

Diagnostics: screenshot

• On the left menu, click Diagnostics.
• The Run Full Diagnostics button will give a full test of your DSL modem connection.
• Three additional tools are provided to troubleshoot your connection:
  • Web Address: Use to test modem's ability to contact web addresses.
  • NS Lookup: Use to test for DNS issues.
  • Trace Route: Use to test for routing issues.

Remote Access: screenshot

• You can enable remote access to allow a TOAST.net technician to access your modem for troubleshooting or configuration. On the left menu, click Remote Access.
• Enter a remote access password if desired, then click the Enable button.
• Note the URL listed on the screen. This is the address you will need to use in a web browser to access the modem.